LDM 100+mW Infrared Laser Designator Short Case Scopes/Mounts/Rings & Optics > Tactical Scopes > Other Head-Up Optics for sale, gun classifieds or gun auction from Auction Billing. Buy or bid on this LDM 100+mW Infrared Laser Designator Short Case in the category Non-Guns > Scopes/Mounts/Rings & Optics > Tactical Scopes

Description

Shipping and payments

Additional information

YOU NEED NIGHT VISION TO SEE THE LASER DESIGNATOR, THE PICTURE OF THE LASER ACTIVATED IS TAKEN WITH A NIGHT VISION CAMERA. THIS IS NOT A GREEN LASER.THE LASER IS DESIGNED FOR LONG RANGE OPERATION.

Look at Picture #4 after 24 hours in cold storage at 14 degrees F the laser will operate at more than 50% (50-60mW) of the power output within 1-3 seconds after activation. Most other lasers stop operating at 50 degrees F my laser is still operating at maximum power at that temperature power table listed below.

Please note this item is custom hand machined not mass produced. This item was requested by Military &LE to keep up range/recoil requirements for the Barrett .50 and .338 Lapua Magnum. A 3 Volt single cell CR123A is required. The laser measurements are approx 4.5 inches long x 1 inch round. If there is any questions or issues email me PRIOR TO BIDDING.

BRAND NEW Internal Zeroing System.

BRAND NEW Laser Defense MFG 100mW IR Laser Sight Rail Mounted Laser. This laser housing design does not use cheap bands and rubber O-rings to hold the laser module in place like most of the laser manufacturers do. The laser module is mounted to a Patent Pending U-Joint which lets the laser module pivot for zeroing but will hold zero and will return to zero every time. Once the laser is zeroed on your weapon and it is removed as long as it is re-mounted in the same location and clock position there will be no need to re-zero the weapon. The windage elevation adjusters are ball lock click adjustment which will hold and lock pressure to keep the laser module dead on. The adjusters are protected by removable covers to prevent the loss of Zero during tactical/combat maneuvers. If the laser is inadvertently bumped/shocked the windage/elevation adjusters are below the laser caps therefore cannot be knocked/bumped out of adjustment. The laser unit is water resistant and totally sealed. Rail Mount for 20mm pica tinny Rail included. Coiled pressure pad remote included. Push On and constant on button included. Uses one CR123A Battery included. Laser housing is constructed with a non reflective black 6160 T6 aircraft aluminum body and is custom made.

Case material:

6000 Series machined aircraft aluminum with black anodized military hard coated finish. High impact, chemically resistant engineering polymer laser housing.

Dimensions (LxWxH):

4 inches long by 1 inch round weight (w/ batteries):

1.6 oz

Operating Temp/ working temp

-20c*-+60c 4F*-140F

*Power level is reduced

Laser Output 100mW 832nm Infrared Laser Class IIIB laser

Run Time:

2.0 hours continuous run time, Laser

Battery: One (1) CR-123A

Power Output Celsius -20C to-10C power 40-50mW

Power Output Fahrenheit -10C to+5C power 50-70mW At or Above+10C power 100mW 4F to 23F power 40-50mW 23F to 41F power 60-70mW

At or Above 41F power 100mW

LDM 100+mW Infrared Laser Designator Short Case

Listed in category: Non-Guns > Scopes/Mounts/Rings & Optics > Tactical Scopes > Other Head-Up Optics