The Springfield Armory XD(M) Compact in 9mm

Authors Paul Helinski Pistols

The Springfield Armory XD(M) Compact is made in Croatia like the rest of the XD line. It is an extremely high quality handgun that can go head to head with any striker fired pistol on the market and most likely come out on top. This is the 13+1 compact configuration with the flush magazine.

It also comes with a 19 round magazine that has a sleeve that matches the thickness of the grip for a full 3 finger hold similar to the XD(M) 3.8 that has been on the market for a year or so. The interchangeable backstraps on the XD(M) also come with alternate magazine sleeves of the same thickness.

Few parts means few problems, and the XD pistols have as few parts as any pistol on the market. You need never take the gun down further than this to clean it.

Few parts means few problems, and the XD pistols have as few parts as any pistol on the market. You need never take the gun down further than this to clean it.

Simple disassembly and re-assembly is a big selling point for the XD line. You lock the slide back, flip that lever, and the slide comes off the front.

Simple disassembly and re-assembly is a big selling point for the XD line. You lock the slide back, flip that lever, and the slide comes off the front .

One thing that the XD(M) line did was eliminate the need to pull the trigger to remove the slide. This is a big safety benefit. Make sure any gun is empty before you clean it. Check it again, even if you feel like you already checked.

The numbers don’t lie. Springfield claims that the XD(M) pistols have the shortest trigger pull of any striker fired pistol, and at a consistently measured .3 inches, I don’t doubt that this is true.

Reset is one of those things that after someone tells you what it is you say to yourself “oh yea, that is important!” and the Springfield XD(M) we tested had a consistent reset at .2 inches.

We only tested accuracy on this two tone XD(M) Compact at 25 feet. Most gunfights occur at less distance than that and with such a short sight radius any longer range testing would be pointless. The gun shot out of the box to point of aim and into a ragged hole. What more do you need?

The XD Gear has been a staple of the line since its inception and the new holster that comes with the XD(M) is as good as any aftermarket paddle holster you could buy.

Springfield Armory

https://www.springfieldduel.com/

New this year from Springfield Armory is their latest entrant into their line of XD(M) polymer framed striker fired pistols. This is what is being called the XD(M) Compact, and it is very similar to the XD(M) 3.8 that came out last year and that was built on their standard size frame with a shorter barrel and slide. The Compact  has the same 3.8 inch barrel, and the slide is the same. But the frame is a new design for Springfield and it is made specifically for concealed carry.

Never to be left with a question about thinking about everything, Springfield gives you two different size magazines with the gun though. The flush magazine is the true “Compact” size and holds 13 rounds, but there is also a full size 19 round that comes with a sleeve to extend the grip. So with one gun you have both the new XD(M) Compact, a 2 finger grip for most hands, and the same gun with a full 3 finger grip, like the older 3.8 model.

If you aren’t familiar with the popular XD pistols from Springfield, they are one of the market leaders in polymer pistols sales, and for a reason. Nearly every feature you see advertised these days in polymer pistols has come standard on the XD since the beginning. Standard features include a front rail, ambidextrous safety, loaded round indicator, three dot Novak style sights, a striker status indicator, aggressive slide serrations, grips you can hold onto, an ergonomic design, and both a trigger and grip safety. The XD line was also the first to come with a belt holster standard, as well as a magazine holder and functional magazine loader right in the molded plastic case with the gun..

The XD(M) guns go even one step further. They come standard with match grade barrels, interchangeable backstraps and even more aggressively molded grips, as well as advanced finish and usability features that can be found on the XD(M) subsite at https://www.the-m-factor.com/.

Most important I feel in the XD(M) improvements is what Springfield claims to be the shortest trigger pull in the polymer pistol market.  I measured the pull using my handy digital caliper and the trigger pull is indeed extremely short, .3 inches.  Until I go measure the Glock, M&P, etc., I will reserve judgment on the actual shortest, but that is pretty short.  I was surprised it measured that short, and I measured it several times from different angles on the trigger..

The “reset” is another measurement that only a few companies even talk about in the pistol world. It is what separates the men from the boys and the ladies from the girls in a striker fired pistol.   Reset is how far forward the trigger has to travel before it can be pulled again for a subsequent shot.  An audible and tactile click on the XD(M) tells you instinctively that the gun is ready for the next shot and on this test gun I measured the reset at .2 inches. From what I have seen, this is the standard upon which others should be judged at this point.  The XD(M) action is a bit spongy, like all striker fired pistols, but you do instinctively know when it is going to bang, though it will take you a couple magazines to develop a feel for it. We almost got thrown off the range for rapid fire because I had to see if I could get 5 rounds off before any brass hit the floor. I could.

You get a little tired of writing that the gun didn’t have any failures over the course of several hundred rounds, but indeed that was the case with this XD(M) in 9mm that we tested. I took it out for a test drive for an afternoon at the Bass Pro Shops range (with all the pesky rules that make little sense) with a friend who hadn’t fired a gun in 30 years, and his two boys, aged 17 and 21.  We shot several brands of 9mm roundball range ammo, plus some Hornady Critical Defense in the 115 grain FTX.  Some people find the XD guns a little too top heavy, but I find, and my guests also found, that the slight top heavy’ness keeps the flip down. For new and lapsed shooters I was surprised at how comfortably they shot the gun, and how little flip affected their shooting.

Accuracy was best with the hot, light 115 grain Critical Defense. I don’t know if this is intentional on Springfield Armory’s part. It could just be attributable to the consistency of Hornady ammunition, whereas inexpensive range rounds are not expected to be overly accurate.  At 25 feet the gun shot consistently into an inch to an inch and a half using the Hornady Critical Defense.

We didn’t change out the backstraps because you need a punch to take out the set pin. The good side of this is that you won’t have your backstrap come off accidentally, but I’m not sure I have a tool that would work to change the backstrap out myself. When you do change the backstrap, and it can go both thinner and thicker, Springfield also gives you two extra sizes of magazine sleeves for the 19 round magazine, so the thickness of the grip is consistent. Attention to detail matters, and the XD(M) pistols have not one stone unturned.

In an extremely crowded field of 9mm compacts, the XD(M) Compact is for sure a standout. Go online and Google around yourself. You won’t find a lot of complaints about the XD(M) guns, and that can’t be said for a lot of other market leaders. All the way from Croatia, the Springfield XD(M) Compact is worthy of your hard earned dollars, and you will consider it a solid purchase that you will never regret.

Springfield Armory

https://www.springfieldduel.com/

Leave a Reply

Your email address will not be published. Required fields are marked *

  • Mike March 24, 2012, 10:37 pm

    The kit is great if you are right handed. Left handed? Might as well throw the holster away even though it is a great one!

  • Timothy Copeland June 15, 2011, 9:46 am

    I own the xdm 3.8 9mm. This the first handgun I have really used, I was more for rifles and shotguns. My wife and I went to Frontsight 4 day handgun course. I started out poorly but the more I got use to the pistol I found it very easy to use. It did not jam once during the firing of 650 rounds that week. By the end of the week I was shooting much better. My wife shoots a kimber 9mm, she finds mine easy to use when racking the slide. I think I will look into this new version, for conceal carry.

  • wayne martin May 11, 2011, 12:31 am

    This is the number one gun in my book…I have been saving my money for this and I have 500 dlrs saved so for…I have a Glock 22 but I feel this gun is going to replace my glock…I have just about all the articles on this gun and my wife knows this is the gun I am ready to buy.

  • Jerry May 9, 2011, 10:39 pm

    The article says, as with Glocks and ALL XD’s the trigger needs to be pulled to remove the slide. That is wrong see the link below. Please correct this miss-information. The (M) did away with this dangerous practice.

    http://www.the-m-factor.com/html/innovation.html

    Thanks

    • Administrator May 9, 2011, 11:02 pm

      Thanks for catching that. It has been changed.

  • Amir May 9, 2011, 9:35 pm

    THe stroke of a trigger does not mean that its spec’s are superior to another firearm. I really do not see what the compareable points of this competition are? there is no real criteria outlined.

  • William Olson May 9, 2011, 7:22 pm

    Please! Send me info on buying a XDN W/ two additional 19 magagine’s, Its the Compact 9 MM. Thank You

  • Erik S. May 9, 2011, 5:01 pm

    I bought one of these at Bass Pro Shop in Pearland, TX. They are at the low end of the price scale–so if you have one-go check them out there. I have large hands and the 19 fd mag does the trick so when carrying (which I don’t yet) I plan to use the 13 rd. and for the range the 19 rd. Thanks

  • Gary May 9, 2011, 2:58 pm

    I am having problems identifying which XD I have as it is confusing. It says Compact and is a 3.8; but what model is it? How do I tell if it is an XD (M) or what, can you give a clear presentation of what comprises which model. Thanks! P.S. It shoots beautiful and I like it much better than a Glock, Night Sights are next and Magazines with Finger Grove (not extended capacity) even with small hands it is too small, this should make it better.

    • Administrator May 9, 2011, 4:31 pm

      This is the XD(M) Compact. It has a 3.8″ barrel.

  • Omar Little May 9, 2011, 2:13 pm

    @ Chris Cano,

    you can find this gun for about $575-$700 range, depending on your dealer. I can see a whole bunch for sale on GunsAmerica – http://www.gunsamerica.com/Search.htm?T=xdm+9mm+compact

    GunsAmerica doesn’t actually sell anything – the dealers do. Buy one, it’s a great gun.

  • Chris cano May 9, 2011, 9:31 am

    Hello I want to purchase a gun it’s my first I wanted to know the price of this one and what do u need from me so I can purchase it thank you Chris Cano

Send this to a friend