RUGER VAQUERO XR3-RED GRIPS 

Grips Also Fit New Model Single Six, Super Single Six, Hawkeye, Old Army, New Model Blackhawk & Super Blackhawk With the Round Trigger Guard Only, 

Not Super Blackhawk With the Square Trigger Guard. 

Smooth With Relief Carved Vaquero Cowboy on Right Grip 

Relief Carved Grips Were Designed & Carved By K Dennis Holland. 

These Grips Are Direct Reproductions From Dennis Holland's (KDH) Beautiful Artisan Work. 

Classic Ivory-Like Reproduction Grips 

Ivory-Like Grips Are Made of an Engineered Urethane That is Perfect For Reproducing Beautiful Grips. Will not chip or shrink! 

If You Have a Ruger Single Six or Ruger Blackhawk 1962 - 1972, It Is Important to Check Your Backstrap & Read the Markings Under Your Grips. 

Ruger Changed Grip Frame Sizes Around This Time on Many Models. 

Simply Remove the Grips to Determine Your Grip Frame Model. 

The Ruger Vaquero XR3-RED Made From 1972 to 2004 is Normally Marked on the Frame With Raised Letters Under the Grips: XR3-RED. 

However, This Lettering Can Be Different But Still Use the XR3-RED Grips. 

They Can Read: XRN-3RED, NXR3-RED or NRM-3RED. 

The Ruger Vaquero made from 1 is referred to as the XR3-RED Model. 

This is easily determined as XR3-RED is stamped in the grip frame under the grips. 

Simply remove the grips to determine if your Model applies. 

The Ruger Firearms Made from 1962-72 May Be the "Three Screw Model" But the Frame Size Was Changed to the XR3-Red.  

It Is Important to Read What Is Under the Grips to Be Sure You Order the Correct Size Grips XR3 Versus XR3-Red 

Stainless Models are Harder to Fit, Because They Have Slight Variations. Our Grips Are Not Guaranteed to Fit Stainless Steel Frames. 

Does Not Fit Early Single Six, Early Flat Top Blackhawk, Ruger New Vaquero 2005 50th Anniversary XR3, Ruger Single Seven Lipsey, Or Ruger 50th Anniversary 2006 Blackhawk .357

MADE IN THE USA